12
3. Front Post and Tension Control Knob Installation
Remove six M8x15 Bolts (41), Ø20xØ8 Curve Washers (42), Ø8
Spring Washers (60) from the Main Frame (1).
Insert the Tension Cable (30) through into the bottom hole of Front
Post (5) and pull it out from the square hole of Front Post (5).
Connect the Sensor Wire II (68) from the Main Frame (1) to the
Sensor Wire I (67) from the Front Post (5).
Insert the Front Post (5) onto the tube of the Main Frame (1) and
secure with six M8x15 Bolts (41), Ø20xØ8 Curve Washers (42), and
Ø8 Spring Washers (60) that were removed.
Remove the Ø20xØ5.2 Curve Washer for Tension Control Knob (64)
and M5x45 Bolt for Tension Control Knob (65) from the Tension
Control Knob (54). Put the cable end of resistance cable of
Tension Control Knob (54) into the spring hook of Tension Cable (30)
as shown in drawing A of figure 3. Pull the resistance cable of
Tension Control Knob (54) up and force it into the gap of metal
bracket of Tension Cable (30) as shown in drawing B of figure 3.
Attach the Tension Control Knob (54) onto the Front Post (5) with
the Ø20xØ5.2 Curve Washer for Tension Control Knob (64) and
M5x45 Bolt for Tension Control Knob (65) that were removed.
Tool:
1
5
30
60
60
64
65
68
67
41
42 41
54
30
54
54
30
30
B
A
Multi Hex Tool with Phillips
Screwdriver S8, S13, S14, S15
Allen Wrench 6mm
