8
Tool:
Double Open End Wrench 13#, 15#
2
1
10
22
29
28
3
28
29
ASSEMBLY INSTRUCTIONS
1. Front and Rear Stabilizers Installation
Remove the Ø8 Safety Pin (22) from the bike. Pull the Rear and Front Frames (1, 2) apart
from each other. Align pin holes for inserting the Ø8 Safety Pin (22) then insert the
removed Ø8 Safety Pin (22) into the holes on the Rear and Front Frames (1, 2) to lock the
frames in place.
Position the Front Stabilizer (10) in front of the Front Frame (2) and align bolt holes.
Attach the Front Stabilizer (10) onto the front curve of the Front Frame (2) with
two
Ø8xØ25x1.5 Big Curve Washers (28) and two M8 Hexagon Cap Nuts (29). Tighten cap
nuts with the Double Open End Wrench provided.
Position the Rear Stabilizer (3) behind the Rear Frame (1) and align bolt holes.
Attach the Rear Stabilizer (3) onto the rear curve of the Rear Frame (1) with
two
Ø8xØ25x1.5 Big Curve Washers (28) and two M8 Hexagon Cap Nuts (29). Tighten cap
nuts with the Double Open End Wrench provided.
Hardware:
(28) Big Curve Washer Ø8xØ25x1.5
4 PCS
(29) Hexagon Nut Cap M8
4 PCS
