www.LifeIonizers.com/Support
18
75
M7/M7 UC NG
AMPERAGE AND LITERS PER MINUTE (LPM)
NOTE: the unit must be dispensing water before pressing the buttons.
• Press and hold
“FILTER 1”
&
“FILTER 2”
simultaneously for 5 seconds in order
to enable the display of the Amperage & LPM reading indicator light.
• Two numbers will then appear on the indicator.
• The top number is the amperage number followed by the digit A.
• The bottom number is the Liters per Minute (LPM) followed by the
digit L.
• Once the LPM is displayed, you can make the necessary adjustment to
the water flow in order to adjust the LPM to the unit.
KEY NOTE: The slower the flow, the stronger the alkaline or acidic
water is produced. We recommend that you set the machine between
a flow of 1.5-2.5LPM.
• For strong 11+pH alkaline or 2.5 pH acid water, we recommend that
the flow rate be set at 1.1-1.5 LPM. Do not set below 1.0 LPM because it
will error out and display E1.
NOTE: Your pH will be determined by your water source. If you’re on
well water, your water is soft, or your TDS is too low, then you might
need a remeneralizing cartridge or a pre-filter to add alkaline minerals
so your unit can ionize properly.
SOUND/VOLUME ADJUSTMENT (F10)
NOTE:
the unit must be dispensing water before pressing the buttons.
To enter the F10 or Volume Adjustment please do the following:
• Press and hold the
“MENU”
button for 5 seconds.
• Once you do this F10 will appear on the display and below that it will
show a number.
• To increase volume, press and release the
“FILTER 2”
button, to
decrease the volume setting press and release the
“FILTER 1”
button.
NOTE:
FLOW RATE MUST BE SET BEFORE ADJUSTING OR RUNNING YOUR IONIZER.
Set flow rate no higher than 2.5 liters per minute. Anything higher could cause internal damage.
Function Options
Amperage &
LPM indicators
Summary of Contents for M9 Next Generation
Page 1: ......
Page 50: ...revised 3 4 15 ...