16
LIFE LC-30 C/UC
LifeIonizers.com/support
LIFE LC-30 UC Installation
(under counter)
(help video on LifeIonizers.com/support)
Angle stop valve
Cold water connect valve
1. Find the raw water
valve under sink.
Turn the main valve
(angle stop) off.
2. Take off the cold
water line from the
angle stop valve as
pictured.
3. Totally disconnect
the line as shown
above.
COLD WATER CONNECT
4. Connect the Cold Water
Connect to the angle stop
valve. Then connect the cold
water line to the Cold Water
Connect valve.
5. Close tight with pliers.
6. Unscrew the nut from the Cold Water Connect. Place the
1/4” tubing through the nut and over the opening. Press
the 1/4” tube onto the barb fitting. Screw the nut back
onto the Cold Water Connect over the tubing. Tighten
the nut with pliers. Tubing should now fit snugly onto the
Cold Water Connect.
7. Run the other end of the 1/4” tubing to the
(IN)
on the pre-filters. Connect another
piece of 1/4” tubing to the
(OUT)
on the Pre-Filters. Turn on water flow from the Angle
Stop and open screw on cold water connect by backing it out counterclockwise with a
flat head screwdriver.
Run 2-3 gallons of water through the pre-filters into a large container or sink. This will
flush out the new Pre-Filters. Turn water source
OFF.
Connect the 1/4” line coming from the
(OUT)
of the Pre-Filters to the
INLET
on the
bottom of the ionizer (You will need to remove the plugs first).
Refer to the Under Counter Quick Start Installation Guide
on LifeIonizers.com/support
(Add Teflon tape to
the exposed threads)