26
How to remove the computer console
In order to remove the computer
console, a flat head screw driver
will be needed to press a plastic tab
that is located on the rear of the
computer. This plastic tab locks
into place on the E1 central support
tube. The plastic tab will need to be
pressed while the computer console
is pushed upward until the tab is
free.
Plastic tab on
the computer
The hole on the
Center support tube
that the plastic tab
on the computer
locks into.
Once the computer is free from the center
support tube hole, slowly pull the
computer away. Be careful to not pinch
or cut the computer wires while moving
the computer away. When the computer
console is ready to be re-installed, make
sure that the computer wires are secure.
While sliding the computer on, push the
computer wires back into the center
support tube and be very careful to not
pinch or bind up the wires.
NOTE: That the plastic cover on the front of the
central support tube may need to be pushed down
to expose the opening.
