Page | 8
Step 8: Stop Bar & Right Handle Bar
Assembly
Tool Needed:
5mm Allen wrench
1) (
See Figure 8
) Insert the stop bar (P)
into the receiver and tighten it with bolt
(J9).
2) Connect hand pulse wire (A6) to hand
pulse sensor wire (F2-1) which is
coming out of right side handle bar (F2).
3) Secure the right handle bar onto seat
frame by tightening the bolts (J5). Make
sure not to pinch the wires while
tightening the hardware.
Step 9: Pedal Assembly
1) Locate the right pedal. There is Left and
Right marker on the pedal itself for
identification.
2) Attach the right pedal (M2) into crank
arm by threading it in a clockwise
direction.
3) Attach the left pedal (M1) into crank arm
by threading it in a counter-clockwise
direction.
4) Use wrench and apply additional torque
to make sure the pedals are extremely
tight. (Torque wrench is preferred.)
5) Afterwards, insert the pedal straps into
the pedals and push down the “PRESS”
button to lock in place.
Figure 8
Figure 9
