Page | 5
Step 2: Front Stabilizer Assembly
Tool Needed:
13mm wrench
(
See Figure 2
) Attach the front stabilizer
(B1) to the main frame with bolts (B3), arc
washers (B4) and nuts (B5).
Note:
Once the stabilizers are assembled,
check to see if the machine is stable. If the
machine is unstable, adjust the (C2) rear
end caps to level the machine.
Step 3: Central Support Tube Assembly
Tool Needed:
5mm Allen wrench
1) Slide the decorative cover (E2) onto the
bottom of the central support tube (E1).
2) (
See Figure 3
) Connect heart rate wire
(E3) to lower heart rate wire (A3) and
connect computer wire (E4) to the servo
motor cable (A2).
3) Place the central support tube (E1) on
the main frame and use bolts (A9) to
tighten the central support tube.
Note: Ensure that all wires are properly
connected and stored inside the central
support tube. Be careful not to pinch the
wires.
Figure 2
Figure 3
