Page | 6
Step 4: Front Handle Bar Assembly
Tool Needed:
6mm Allen wrench
4mm Allen wrench
1) (
See Figure 4
) Place front handle bar
(D) onto the metal plate of the central
support tube (E) and tighten the handle
bar with bolts (E5) and washers (E6).
2) Position the water bottle holder (L1) in
the middle of the central support tube
(E) and tighten it with 2 screws (L3).
Step 5: Console Assembly
Tool Needed:
Philips screw driver
1) Remove screws (G2) from the back of
console housing.
2) Connect computer wire (E3) and heart
rate wire (E4) to console (G).
3) (
See Figure 5
) Slide console (G) onto
the central support tube (E1). Secure
and tighten the console onto the central
support tube with screws (G2).
Note:
To prevent wire being pinched,
please make sure the wires are pushed
back and stored inside the central support
tube before sliding and tightening the
console.
Figure 4
Figure 5
