Page | 7
Step 6: Seat Pad Tube and Back Pad
Assembly
Tool Needed:
6mm Allen wrench
5mm Allen wrench
1) (
See Figure 6
) Connect seat pad tube
(K) to seat frame (A5) using bolts (J1)
and washers (J3).
2) Assemble the back pad (H2) onto seat
pad tube (K) and tight it by washers (J5)
and bolts (J4).
Step 7: Stop Bar & Handle Bar Assembly
Tool Needed:
4mm Allen wrench
6mm Allen wrench
1) (
See Figure 7
) Insert the stop bar (P)
into the receiver and tighten it with set
screws (A4).
2) Connect hand pulse wire (A8) to hand
pulse sensor wire (F3) which is coming
out of right side handle bar (F1).
3) Secure the right handle bar by tightening
the bolts (A5-1) & washers (A5-2). Make
sure not to pinch the wires while
tightening the hardware.
4) Repeat the same procedures for left
handle bar assembly.
Figure 6
Figure 7
