LifeCore Fitness VST-V8, User'S Product Manual

Page

|

8

Step 5: Handlebar Assembly 
 

Tools Needed: 
5mm Allen wrench 

Note: Add the supplied blue loctite in the owner’s 
manual bag to the threads of the (J10) bolts for 
added support. 

 
A. Only remove the two lower preinstalled (J10) 

screws from the left handle bar (E1). Slightly 
loosen the top (J10) bolts, but do not remove. 

B.  As shown in View G) Assemble the left handle bar 

(E1) onto the main frame (A). Apply the supplied 
blue loctite to the treads of all four (J10) bolts, and 
using the 5mm Allan wrench to tighten the four 
(J10) bolts firm.  

Note: Make sure to tighten handle bar bolts tight 
to prevent a clicking noise in the handle bars. 
Wiggle the handle bars to help seed bolts in place 
and then retighten.  

 
C.  Repeat the same steps for the right handlebar 

(E2).  

Step 6: Central Supporting Tube and Water Bottle 
Holder Assembly 

Tools Needed: 
5mm Allen wrench 

6mm Allen wrench 

Note: Make sure that all wires are connected 
together properly; all (J1) bolts are tight to prevent 
a loose central support tube. 

A. Connect wires (D1 & D2) from the central 

supporting tube (D) to wires (A1 & A2) from the 
main frame (A).  

 
B.  Slide the central supporting tube (D) onto the 

main frame (A). Store excess wires into the tube. 
If needed, loosen the preinstalled (J1) screw in 
the main frame (A) to help slide central supporting 
tube down or to help align holes for the (J1) 
screws M8x16.   

 
D.  Apply the supplied blue loctite to the treads of 

both (J1) bolts M8x16, and using the 5mm Allan 
wrench tighten the four (J1) bolts M8x16 tight.  

 
C.  Use the two (J6) screws located in the water 

bottle holder bag to join water bottle holder (H) to 
the main frame (A).