1.3 S
ETUP
Read the Operation Manual before setting up the Total Body Trainer.
E
LECTRICAL
P
OWER
R
EQUIREMENTS
The Total Body Trainer requires an AC power supply according to the electrical configurations
listed in the chart below.
NOTE:
Do not modify the plug provided with this product. If the plug does not fit into an available
electrical outlet, have a proper outlet installed by a qualified electrician.
H
OW TO
P
OSITION AND
S
TABILIZE THE
T
OTAL
B
ODY
T
RAINER
Following all safety instructions in Section 1.1, move the Total Body Trainer to the location in
which it will be used. See Section 7, titled
Specifications,
for the footprint (product dimensions).
Allow one foot of clearance in front of the Total Body Trainer to allow for movement of the pedal
levers. It should be easy to mount the Total Body Trainer from the side.
After placing the Total Body Trainer in position, check
the unit’s stability by attempting to rock it. Any slight
rocking indicates that the unit must be leveled. Check
the front stabilizing feet to determine which foot does
not rest fully on the floor. Rotate the foot counter-clock-
wise to lower it. Recheck the stability and adjust again
as needed until the Total Body Trainer is stable and no
longer rocks.
Lock the adjustment into position by tightening the
jam nut against the stabilizer bar with an open end
17mm wrench.
8
Supply Voltage
(VAC)
100
110
120
200
220
230
240
Frequency
(Hz)
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
Rated Current
(Amps)
1.6
1.6
1.6
.8
.8
.8
.8