19
8.4
Tracking (Centering) an Existing or New Walking Belt
1. Locate the two access holes to the belt tensioning bolts (A) on each of the
rear roller guards.
2. Stand on the sides of the Treadmill Desk and straddle the belt. Press GO and
set the belt speed to 2.0 mph. (3.2 kph)
3. If the walking belt has moved to the right, turn the right tension bolt 1/4 turn
clockwise with the provided 6mm hex key wrench, and then turn the left
tension bolt 1/4 turn counter-clockwise to start walking belt tracking back to
center of roller.
4. If the walking belt has moved to the left, turn the left tension bolt 1/4 turn
clockwise and then turn the right tension bolt 1/4 turn counter-clockwise to
start walking belt tracking back to center of roller. Repeat adjustments until
the walking belt appears centered. Allow the machine to continue running
for several minutes to observe if tracking remains stabilized.
Note:
Do not exceed one full turn of the adjusting screws in either direction. If after one full turn the belt does not track
properly, contact Customer Support Services.
8.5 Using and Testing the Safety Stop Pull Cord
During operation of the
Treadmill Desk, the lanyard on the Safety Stop pull cord should be attached to an item of the
user’s clothing.
While the Treadmill Desk is ON and the console display is active remove the Safety Stop pull cord from the Treadmill
Desk. A message shall be displayed on the console similar to “- - - - - -”. With the Safety Stop pull cord removed no keys
shall function on the Treadmill Desk.
8.6 How to Obtain Product Service
1. Please contact Life Fitness Customer Service at 1.800.351.3737.
2. Verify the symptom and review the operating instructions and troubleshooting matrix.
3. Locate and document the serial numbers on the Treadmill Desk
(located on the front base frame; user’s left).
Please have proof of purchase information available.
A
A
Base Serial Number Label