OPERATING INSTRUCTIONS
Remove sticker from face of thermometer
To Install Battery:
Battery Type: AAA. Use
fingernail or coin to lift up battery cover and insert
battery in direction indicated.
Digital Display Indications:
IN = AIR/ROOM TEMPERATURE
OUT = PROBE/WATER TEMPERATURE
Place probe with suction cup inside aquarium or
wet/dry filter. Fully submerge probe under water. Do
not submerge meter or allow meter to get wet.
Damage may occur.
To Set Alert:
1. HIGH TEMP ALERT ONLY (Probe)
Slide “Temp/Alert” switch to “Alert”. Press “Alert/Select”
button to High Temp alert mode. ( symbol will appear
on display.) Press “High Set” button to set desired high
temperature point. Press “Alert On/Off” button to
activate alert feature. (“Alert” will appear on display.)
Slide “Temp/Alert” switch back to “Temp”. Alarm sounds
and LED light flash for 5 seconds every minute when
temperature is above High temperature set point.
2. LOW TEMP ALERT ONLY (Probe)
Slide “Temp/Alert” switch to “Alert”. Press “Alert/Select”
button to Low Temp alert mode. ( symbol will appear
on display.) Press “Low Set” button to set desired low
temperature point. Press “Alert On/Off” button to
activate alert feature. (“Alert” will appear on display.)
Slide “Temp/Alert” switch back to “Temp”. Alarm sounds
and LED light flash for 5 seconds every minute when
temperature is above Low temperature set point.
3. BOTH HIGH & LOW TEMP ALERT (Air/Room)
Slide “Temp/Alert” switch to “Alert”. Press “Alert/Select”
button to High & Low Room temp alert mode.
( symbol will appear on display.) Press “High Set”
button to set desired high temperature point. Press
“Low Set” button to set desired low temperature point.
Press “Alert On/Off” button to activate alert feature.
(“Alert” will appear on display.) Slide “Temp/Alert”
switch back to “Temp”. Alarm sounds and LED light
flash for 5 seconds every minute when temperature is
above High or below the Low set point.
4. BOTH HIGH & LOW TEMP ALERT (Probe)
Slide “Temp/Alert” switch to “Alert”. Press “Alert/Select”
button to High & Low Probe temp alert mode.
( symbol will appear on display.) Press “High Set”
button to set desired high temperature point. Press “Low
Set” button to set desired low temperature point. Press
“Alert On/Off” button to activate alert feature. (“Alert” will
appear on display.) Slide “Temp/Alert” switch back to
“Temp”. Alarm sounds and LED light flash for 5 seconds
every minute when temperature is above High or below
the Low set point.
Big Digital
TEMP ALERT
™
Use with pop up
stand...mount with
screws...or attach
to any surface with
pressure sensitive
adhesive pad.
Made in China
Email: info@lifegardaquatics.com
Web Site: www.lifegardaquatics.com
