While the pump is
sitting on the base
sponge slide the
pump gntly into the
4
th
Chamber of the
back filter.
Side view
of how the
pump should sit all the
way on the bottom of
the tank.
Slide the open end of the
insert elbow out of the
top hole – as shown above
Slide the rubber seal onto the
open end of the elbow from
the aquarium side – as shown
above
Gently Push the rubber seal
so it sits flush with the wall
of the back filter – as shown
above
Slide the Directional
Jet assembly into the
rubber seal
It should look like this
once installed correctly
flushed with the wall
Place the Clear Plastic
Clips that will hold the
glass lid.
Note how the clips are places
on the edges for proper grip
of the glass lid.
Place the glass lid on the
plastic clips.
Back View - LIFEGARD® FULL VIEW – Without the back filter. Shown
here with LIFEGARD® Full Spectrum LED Light, LIFEGARD® Pre Set
Heater and LIFEGARD® Internal Power Filter.
Front View - LIFEGARD® FULL VIEW – Without the back filter. Shown
here with LIFEGARD® Full Spectrum LED Light, LIFEGARD® Pre Set
Heater and LIFEGARD® Internal Power Filter.
Back View - LIFEGARD® FULL VIEW – With the back filter. Shown here
with LIFEGARD® Full Spectrum LED Light, LIFEGARD® Pre Set Heater and
the full layout of the pack Filter.
Front View - LIFEGARD® FULL VIEW – With the back filter. Shown here
with Bottom Strainer installed, Directional Jet and the O2/CO2 Airline
Tube hole.