8
2. Install the Seat Cushion and Seat Post
Remove three M8 Locknuts (45) and three Ø8 Washers (48) from underside of the Seat
Cushion (20).
Guide bolts on underside of the Seat Cushion (20) through holes on top of the Seat Post (21),
attach with three removed M8 Locknuts (45) and three Ø8 Washers (48). Tighten locknuts
with the Multi Hex Tool with Phillips Screwdriver provided.
Insert the Seat Post (21) into the Bushing (22).
Adjust the seat position and insert the Round Knob (19). Turn the Round Knob (19) in the
clockwise direction to tighten.
NOTE: When adjusting the height of seat post, the maximum insert depth mark line
cannot higher than the edge of bushing.
20
48
45
19
21
1
22
Multi Hex Tool with Phillips Screwdriver
S13, S14, S15
Tool:
