8
6. Install the left and right Pedals
Attach the left and right Pedals (10) to the Crank (20).
The left Pedal (10) should be threaded on
counter-clockwise. The right Pedal (10) should be
threaded on clockwise. (See figure 6)
NOTE:
The Pedals (10)
and Crank (20) are marked
with
“
R
”
&
“
L
”
.
7. Maintenance and Treatment
1) Verify that all the bolts and nuts are locked properly and the turning parts should be turned
freely without any scream.
2) Clean the equipment with soap and slightly damp cloth only. Please do not use any solvent to
clean the equipment.
Malfunctions and treatment
Malfunction
Reason
Treatment
Base is unstable.
1. Floor is not flat or there is
small object under the front
or rear stabilizer.
2. The front and rear base feet
have not been leveled when
assembling.
1. Remove the object.
2. Adjust the front and rear base feet.
Handlebar or seat
cushion is shaking.
The screws and round knob
are loose.
Tighten the screws and round knob.
Loud noise from
the moving parts.
The interval of the parts is
improper tighten.
Open the covers to adjust.
No resistance when
riding the upright
bike.
1. The interval of the magnetic
resistance increases.
2. Tension control is damaged.
3. Running belt is slip.
4. The bearing set is damaged.
1. Open the covers to adjust.
2. Change the tension control.
3. Open the covers to adjust.
4. Change the bearing set.
