3
OPERATING INSTRUCTIONS
1. Operate according to your own condition.
2. Adjusting the adjustable leveler:
Turn the adjustable leveler
on the rear stabilizer as needed to level the bike.
3. Adjusting the handlebar:
Hold Handlebar while loosening the T-Knob. Adjust Handlebar to the desired position
and turn the T-Knob in a clockwise direction to tighten.
Note: Continue to turn the T-Knob until Handlebar is secure before exercising.
4. Adjusting the seat post:
Turn the seat height adjusting knob in a counterclockwise direction and then pull out the
seat height adjusting knob. Lock the seat post in place by releasing the seat height
adjusting knob and sliding the seat post up or down slightly until the seat height adjusting
knob "pops" down into the locked position. For added safety, tighten the seat height
adjusting knob in a clockwise direction.
NOTE: When adjusting the height of seat post, the maximum insert depth mark
line cannot higher than the edge of bushing.
5. Adjusting the seat cushion:
Release the knob and then slide the seat cushion forth or back direction for the suitable
position. Tighten the knob after adjustment.
6. Sitting pose: sit on the seat cushion when exercising, please tighten the pedaling straps
and hold the handlebar with hands, adjust your posture according to your exercise
speed and intensity.
COMPUTER OPERATION
Clock Mode:
a. The computer will enter into the clock mode when there is no
signal input or no keys be pressed after 4 minutes. You can
press ENTER key to switch the clock and temperature at the
clock mode or press other keys to quit the clock mode.
b. You can set up the TIME or ALARM by holding ENTER key for
over 2 seconds then you can set up TIME or ALARM by pressing
UP or DOWN key.
c. By holding the ENTER and UP keys together for over two
seconds, you can check the current time at the STOP mode.
Functions and Features:
1.
CLOCK:
Displays time in hour and minute.
2.
ALARM:
You can set up time by this computer and it will beep alarm 1 minute when
your setting time is reached.
3.
TEMPERATURE:
Displays the current temperature.
4.
SPD (SPEED):
Displays your workout speed value in KM/MILE per hour.
5.
TIME:
Displays your elapsed workout time in minutes and seconds. When you start to
exercise, time starts counting up from 0:00 to 99:59 per 1 second increment. You may