9
3. Front Handlebar Post and Foot Pedal Installation
Remove one Ø8xØ20x2 Curve Washer (40), one M8x15 Bolt (72), four M8x10 Bolts (35)
and four Ø8xØ16x1.5 Washers (36) from the Front Main Frame (21). Remove bolts with
the S6 Allen Wrench provided.
Slide the Front Handlebar Post Cover (7) up to the Front Handlebar Post (34).
Insert the Tension Cable (31) through into the bottom hole of Front Handlebar Post (34) and
pull it out from the square hole of Front Handlebar Post (34).
Connect the Sensor Wire (71) and Extension Hand Pulse Sensor Wires II (70) from the Front
Main Frame (21) to the Extension Sensor Wire (26) and Extension Hand Pulse Sensor Wires
I (27) from the Front Handlebar Post (34).
Insert the Front Handlebar Post (34) onto the tube of the Front Main Frame (21) and secure
with one Ø8xØ20x2 Curve Washer (40), one M8x15 Bolt (72), four M8x10 Bolts (35) and
four Ø8xØ16x1.5 Washers (36) that were removed. Tighten bolts with the S6 Allen Wrench
provided. Slide the Front Handlebar Post Cover (7) down to the Front Main Frame (21).
Remove the Ø5xØ20x1 Big Washer (32) and M5x20 Bolt (33) from the Tension Control Knob
(30). Remove bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Put the cable end of resistance cable of Tension Control Knob (30) into the spring hook of
Tension Cable (31) as shown in drawing A of figure 3. Pull the resistance cable of Tension
Control Knob (30) up and force it into the gap of metal bracket of Tension Cable (31) as
shown in drawing B of figure 3. Attach the Tension Control Knob (30) onto the Front
Handlebar Post (34) with the Ø5xØ20x1 Big Washer (32) and M5x20 Bolt (33) that were
removed. Tighten bolt with the Multi Hex Tool with Phillips Screwdriver provided.
12
69
21
72
40
36
35
71
31
70
27
26
7
36
35
34
33
32
30
31
26
27
13
30
31
30
31
B
A
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
Tool:
Allen Wrench S6
