LifeGear 26460, Owner'S Manual

14

DIST (DISTANCE): 

Displays the accumulative distance traveled during workout.    You may 

also pre-set target distance in STOP mode before training.    To set DISTANCE press the 
MODE button until you see the DIST displays on the screen.    Press the SET button to 
change the distance.    Press the RESET button to clear the target distance to zero.    The 
pre-set target distance range is from 0.00 to 9999 km.    Once you pre-set target distance 
and then start to exercise, distance starts counting down from pre-set target distance to 0.00. 
When the pre-set target distance counts down to 0.00, distance will start to count up and the 
computer will begin beeping to remind you. 

 
CAL (CALORIES): 

Displays the total accumulated calories burned during workout.    You 

may also pre-set target calories in STOP mode before training.    To set CALORIES press 
the MODE button until you see the CAL displays on the screen.    Press the SET button to 
change the calories.    Press the RESET button to clear the target calories to zero.    The 
pre-set target calories range is from 0.0 to 9999 calories.    Once you pre-set target calories 
and then start to exercise, calories start counting down from pre-set target calories to 0.0.   
When the pre-set target calories count down to 0.0, calories will start to count up and the 
computer will begin beeping to remind you.    (This data is a rough guide for comparison of 
different exercise sessions and should not be used in medical treatment). 
 

ODO (ODOMETER):

 Displays the total accumulative distance traveled.    The data values of 

ODO can not be clear to zero by pressing and holding the MODE or RESET button for 3 
seconds.    If you take out the batteries from the computer, the ODO data values will clear to 
zero. 
 

(PULSE):

 Displays your current heart rate figures after you grip the handlebar sensors 

with both your hands during exercise.    To ensure the pulse readout is more precise, please 
always hold on to the handlebar grip sensors with two hands instead of just with one hand 
only when you try to test your heart rate figures.    You may also pre-set target heart rate in 
STOP mode before training.    To set PULSE press the MODE button until you see the 
P

displays on the screen.    Press the SET button to pre-set target heart rate.    Press the 

RESET button to clear the target heart rate to zero.    Once you pre-set target heart rate and 
then start to exercise, please grip the handlebar sensors with both your hands during 
exercise.    If the heart rate detected greater than the target heart rate, the computer will 
begin beeping to remind you. 

 
HOW TO INSTALL THE BATTERIES: 

1.  Remove the battery cover on the back of the computer. 
2.  Place two size AA batteries into the battery housing. 
3.  Insure batteries are correctly positioned and battery springs are in proper contact with 

batteries. 

4.  Re-install the battery cover. 
5.  If the display is illegible or only partial segment appears, remove batteries and wait 15 

seconds before reinstalling.