10
Step 3
Connect the Hand Pulse Sensor Wire (62) from the Handlebar (59) to the Extension Hand
Pulse Sensor Wires (64) from the right side of the tube of the Handlebar Support Frame
(26).
install the Handlebar (59) to the right side of the tube of the Handlebar Support Frame (26)
by inserting the Handlebar (59) onto the right side of the tube of the Handlebar Support
Frame (26), using two M8x16 Bolts (43) and two M8 Curve Washers (66). Tighten bolts
with the 5mm Allen Wrench with Phillips Screwdriver provided.
Repeat above steps to assemble the other Handlebar (59) onto the left side of the tube of
the Handlebar Support Frame (26).
Hardware:
Tool:
5mm Allen Wrench with
Phillips Screwdriver
43
66
59
62
59
64
64
43
66
62
26
(43) Bolt M8x16
4 PCS
(66) Curve Washer M8
4 PCS