Feeder Settings:
1. Switch on or off: press the power button for 3 seconds.
2. Setting clock and Feeding time:
● Press "Set" button for 3 seconds, the hour number will flash, press "+" or "-" button to adjust the hour.
● Press the "Set" button again, the minute number starts flashing and press "+" or "-" button to adjust the minute.
● Press "Set" button again – Now you are setting
the first feeding time notice the first square should also be blinking
:
The hour number will flash, press "+" or "-" button to adjust the hour.
● Press the "Set" button again, the minute number starts flashing and press "+" or "-" button to adjust the minute.
● Press "Set" button again, the minute number stops blinking and the ‘first’ square starts flashing, press "+" or "-" button
to adjust the number of feed rotations you want 1, 2, or 3 or none.
This sets up the first feeding time.
If you only need to setup one feed time press the “Manual” button and the settings will be saved.
If you need to setup more feed times – Press the “Set” button again and the hours start blinking but this time the
‘second square’ also flashes. Press "+" or "-" button to adjust the hours. Follow the steps from above to set minutes and
number of feed rotations. Press Manual to save settings.
Continue for a maximum of four (4) feeding times.
NOTE: If you don’t press any buttons the settings will save automatically to the last step after a minute. You can start the
process again at any time by pressing the “Set” button for 3 seconds and keep pressing the “Set” button until you reach
the step you exited programming.
To get more out of your
Lifegard Intelli Feed®
Fish Feeder
Follow us on:
