Figure 4.
Inserting Z-217 Controller Card
[ ] The Data Separator Circuit Board is
mounted on the top of the drive chassis with two
brackets.
Figure 5.
Data Separator Board
All-In-One Computer
[ ] Installation of the hard drive in the Low-
Profile Z-100 is shown in Figure 6. The hard
drive is mounted in the left bay of the drive
chassis. The drive will need a pair of mounting
brackets for the full height drives, but if you
already use half height floppy drives, the same
brackets could be used to mount a half height
hard drive. The Data Separator Board is mounted
over the drive.
If your hard drive has its own faceplate, you
may be able to cut a large opening in your
existing faceplate.
Figure 6.
Data Separator Board
Low-Profile Computer
CABLE CONNECTIONS:
Figure 7 shows the various cable connections on
the rear of an MFM hard drive.
Figure 7.
Hard Drive Cables
8
