lifelong FitPro, Manual

5.3.1

1.  Insert power plug into the socket with earth wire, turn the switch 

to “1” position which is on the frame. Place the safe key to the 

appointed position. After a few seconds, panel will show that the 

machine is ready.

2.  Nip another end of safe key to your clothes, and stand on the 

footplate on both sides.

3. Press “on/off” key, running belt moves at the lowest speed 

(1.0km/h). Speed windows will display your running speed.

4. Start to run.

5.  Press speed key or incline key to adjust speed and incline, speed 

window and incline window will display your speed and incline.

6. To end your exercise in a safe way, please first press “on/off” key 

to close the treadmill. Please leave the running belt until it stops 

slowly. Turn off the power.

5.3.2 Heart Rate Testing

Our treadmill can test your heart rate via the heart rate sensor. The 

data is only for reference.

FOLDING AND OPENING TREADMILL

1. Folding

Firstly lift and fold the back part of the frame board by hand till you 

hear a light sound, which means the folding system has been 

locked. At this time running board can’t be turned to the opposite 

direction.

2. Opening

Put the folded treadmill in a capacious position when you want to run. Then 

pull the adjusting parts by hand to keep it is unlocked. Press the back part by 

your hands down to about 10%, release it, then it will open automatically.

1. 

Identification ways for the degree of tightness of running belt and poly 

V-belt.

When the running belt skips, please follow the steps as follows to make sure 

which belt needs to be adjusted, running belt or poly V-belt.

a)

 Cut off power, screw off the bolt on cover of protection. Then take down the 

protecting cover from the treadmill.

b)

 Turn the speed to be around 3km/h, step on the running belt by pressure 

and try your best to make the running belt stop. If running belt stops, together 

with the front roll, but the motor still runs, under this condition, it means the 

poly V-belt needs to be adjusted.

c)

 Turn the speed to be around 3km/h, step on the running belt by pressure 

and try your best to make the running belt stop. If running belt stops, but front 

roll still runs, under this condition, it means the running belt needs to be 

adjusted.

10

METER OPERATING INSTRUCTION

11

MAINTENANCE