Endurance Training Collection
15
14
Dash X User Manual Lifepro
Endurance Training Collection
15
ATTACH THE CONSOLE/HANDLEBAR FRAME
TO THE BIKE FRAME
1. Remove the eight screws
(17)
from the handlebar inserts
(18)
at the
top of the bike frame.
2. Plug the male console cable
(22)
exiting the handlebar inserts into the
female console cable
(21)
exiting the base of the console/handlebar
frame.
3. Tuck the cables into the open cavity in the handlebar insert.
4. Slide the console/handlebar frame
(15/16)
into the handlebar inserts
(18)
.
5. Insert the eight screws through the screw holes: four on the front side
of the bike frame, four on the back side of the bike frame.
NOTE:
You may need to wiggle the console/handlebar frame slightly to get
the holes to line up for each screw.
6. Use the hex key
(35)
to tighten all eight screws.
6
16
21
15
17
22
21
18
17
22
(17)
x8
TOOLS & HARDWARE
(35)
INSTALL TWO AAA BATTERIES
IN THE CONSOLE
1. Locate the two AAA batteries
(20)
in the tool/accessory bag.
2. Remove the back cover of the console
(15)
.
3. Insert two AAA batteries into the battery compartment according to
the polarity markings in the compartment.
4. Replace the back cover.
CAUTION:
Never mix old batteries and new batteries. Only use AAA
batteries with the console.
5
Cover
20
15
(20)
x2
TOOLS & HARDWARE
