CHARGING THE BATTERY
To charge the Oculax:
1. Ensure the Oculax is OFF before charging.
2. Connect the USB-C charging cable to the charging
port on the bottom edge of the unit.
3. Plug the charging cable into either:
• A USB port on a laptop, computer, or other device, OR
• A 5 V USB adapter such as a 1 A or 2 A cell phone charging adapter (a 2 A
charger will charge faster). Plug the adapter into a standard wall outlet.
CHARGING NOTES
• The Battery Indicator LED will flash during charging. When the battery is
fully charged, the indicator LED will remain lit.
• When the battery is very low, the battery LED will flash, you will hear a beep,
and then the device will shut down automatically. Charge the device before
trying to use it again.
• If you turn the Oculax on and the battery is very low, an alarm will sound.
• The Oculax takes up to 2 hours to charge.
• Average run-time is about 4 hours per charge, depending on the settings in
the programs used (Bluetooth, heat, vibration, etc.).
USING YOUR OCULAX
1. Press and hold the
Power button
on the control panel for 2 seconds to turn
ON the Oculax. Once the unit is powered on, the 5 LED indicators light up.
2. Put the Oculax on your head with the massager positioned over your eyes
and the elastic strap behind your head. The Power button is on your right.
3. Press the
Power button
quickly to toggle between the four available
massage programs (P1–P4) to choose the desired program. Press the Power
button once for P1, twice for P2, three times for P3, and so on. The program
will start after three seconds. Each preset massage program has different
features. Please see the chart on the next page for details.
4. Hold down the
Power button
to turn off the unit at any time. Always power
off the unit after each use.
NOTE:
The unit will automatically shut down after your massage program ends.
Press the
Power button
again if you wish to continue using the device.
10
Oculax User Manual Lifepro
Re Fitness Collection
11
MASSAGE PROGRAM DETAILS
Program
Compression
Heat
Vibration
Music
Time
P1: Energize
√
√
√
√
10 min
P2: Relax
√
√
√
15 min
P3: Relieve
√
√
15 min
P4: Sleep
√
√
20 min
SETTING UP BLUETOOTH MUSIC
1. Press and hold the
Power button
for 2 seconds to turn on the Oculax.
2. Ensure your device (cell phone, iPad, etc.) is on.
3. On your device, go to
Settings
>
Bluetooth
and turn on Bluetooth.
4. In the device list, choose “Oculax Smart Eye Massager” to connect to your
Oculax.
5. Control the music playlist and volume from your device.
USING THE CONTROL PANEL
1
2 3 4
5
6
1. Power Button:
Press and hold the Power button for 2 seconds to turn on/
off the Oculax. Quickly press the Power button to toggle through the
4 preset programs.
2. Air Compression Indicator:
Shows that air compression is active.
3. Bluetooth Indicator:
Shows that Bluetooth is turned on.
4. Battery Indicator:
If lit, the battery is fully charged. If blinking, the battery
is low.
5. Vibration Indicator:
Shows that vibration is active.
6. Heat Indicator:
Shows that heat is on.
