ATTACH THE WATER
BOTTLE HOLDER
1. Attach the water bottle holder
(32)
to the main bike frame
(1)
using two M5×15 bolts
(33)
.
2. Use the hex key to tighten the
bolts.
INSTALL TWO AAA
BATTERIES
1. Remove the back cover
(A)
of
the computer monitor
(C)
.
2. Insert two AAA batteries
(B)
into the battery compartment
according to the polarity
markings in the compartment.
3. Replace the back cover.
CAUTION:
Never mix old
batteries and new batteries. Only
use AAA batteries with the
computer monitor.
ATTACH THE PEDALS TO THE MAIN BIKE FRAME
1. Identify the left and right pedals. The left is labeled “L”, the right is
labeled “R”. Identify the left and right crank arms (also labeled with “L”
and “R”).
2. Remove the pedal nut
(28)
from the right pedal
(26)
. Thread the right
pedal
(26)
CLOCKWISE
onto the right crank arm
(27)
.
3. Thread the right pedal nut onto the pedal threads.
4. Use both wrenches to secure the pedal to the crank arm. Use the larger
wrench to tighten the pedal nut and use the smaller wrench to hold the
pedal thread in place. To tighten, turn the large wrench
CLOCKWISE
and
the small wrench
COUNTER-CLOCKWISE
.
5. Remove the pedal nut
(31)
from the left pedal
(29)
.
6. Thread the left pedal
(29)
COUNTER-CLOCKWISE
onto the left crank
arm
(30)
.
7. Thread the right pedal nut onto the pedal threads.
8. Use both wrenches to secure the pedal to the crank arm as you
did in step 4. However, this time, turn the large wrench
COUNTER-
CLOCKWISE
and the smaller one
CLOCKWISE
.
CAUTION:
Do not mix up the left and right pedal nuts.
CAUTION:
Be sure to fully tighten the pedals and pedal nuts. Riding the
bike with loose pedals can cause injury and/or strip the pedals.
8
9
10
1
26
27
29
30
1
A
B
C
32
33
33
33
12
Re Fitness Collection
15
14
X-FlexCycle User Manual Lifepro
Re Fitness Collection
15
