46
C
o
ntrol
solution testing
3. Match the code on the meter with the code
on the test strip vial
If the code on the meter does not match the
code on the test strip vial, press
or
to
match the code number on the test strip vial.
The new code number will flash on the display
for three seconds, then briefly stop flashing,
after which the display will advance to the
APPLY
BLOOD
screen.
If the codes already match, press
to go to the
APPLY BLOOD
screen. When you do not make a
change after five seconds, the display will
advance to the
APPLY BLOOD
screen.
4. Mark the test as a control solution test
Press to
change
APPLY BLOOD
to
APPLY
CONTROL
. You must mark the test before you
apply control solution. Once you have completed
the test, you cannot change the marking.
The meter is now ready to perform a control
solution test.
DCO_06355102A_OU2_OB_CAe.qxd 6/5/08 11:29 AM Page 46
