9
frame and note roller position).Once the belt is loosen, take the bottle of lubricant and apply it to the entire
top surface of the running deck. Tighten both rear roller bolts (matching up the marks for proper position)
to original position. After you have applied lubricant, plug in the power cord, key, start the treadmill and
walk on the belt for two minutes to spread the lubricant.
•
Lubricate the air shocks with Teflon based spray.
SERVICING: IF YOU FAIL TO COMPLY WITH LIFESPAN’S MAINTENANCE AND SERVICING
STEPS ABOVE, YOU MAY VOID YOUR WARRANTY. IF YOU REQUIRE A SKILLED LIFESPAN
REPRESENTATIVE TO UNDERTAKE ONE OF THE STEPS ABOVE, PLEASE EMAIL US AT
lifespanfitness@hotmail.com
.
2 General Cleaning
Use a soft, damp cloth to wipe the edge of the belt and the area between the belt edge and frame. A
mild soap and water solution along with a nylon scrub brush will clean the top of the textured belt.
This task should be done once a month. Allow to dry before using.
On a monthly basis, vacuum underneath your treadmill to prevent dust build up. Once a year, you
should remove the black motor shield and vacuum out dirt that may accumulate.
3 General Care
Check parts for wear before use.
Pay particular attention to the fixing knobs and make sure they are tight.
Always replace the mat if worn and any other defective parts.
If in doubt do not use the treadmill and contact our helpline.
TAKE CARE TO PROTECT CARPETS AND FLOOR in case of leakages. This product is a machine that contains
moving parts which have been greased / lubricated and could leak.
4 Belt/Deck/Roller Lubrication:
The mat/deck friction may play a major role in the function and life of your treadmill and that is why we
recommend you constantly lubricate this friction point to prolong the useful life of your treadmill.
Lubrication is provided with this unit. You should apply the enclosed lubrication after approximately the first
50 hours of operation. We recommend lubrication of the deck according to the following timetable:
Light use (less than 3 hours per week) every 6 months
Medium use (3-5 hours a week) every 3 months
Heavy use (more than 5 hours per week) every 6-8 weeks.
See below procedures for lubricating:
EVERY 2 YEARS
It is necessary that you change your treadmill motor brushes once every 2 years to avoid damaging your
motor. If you fail to change the brushes this may cause the motor to burn out, voiding any warranty.
PLEASE NOTE: TREADMILL MOTOR BRUSHES NEED TO BE CHANGED EVERY 2 YEARS
OTHERWISE MOTOR WARRANTY WILL BE VOID.REFER TO MANUAL
Summary of Contents for BOOMER PLUS
Page 5: ......
