15
ROWER 305
Rope Adjustment
Over time your
ROPE (51)
may stretch. If the
ROPE (51)
doesn’t retract fully into the
UPRIGHT (3)
and
the
HANDLEBAR (9)
doesn’t stay on the
HANDLEBAR HOLDER (50),
make this adjustment. Remove
the
HANDLEBAR COVER (52)
by unscrewing the
SCREWS (M4x15mm) (49).
Loosen the
BOLTS
(M6x1x20mm) (64),
but do not remove them. Pull the
ROPE (51)
until there is a 3/8 inch of gap on the
shaft of the
SHOCK (42),
refer to illustration A. Then entwine the
ROPE (51)
around the
BOLTS
(M6x1x20mm) (64)
using a figure eight pattern and tighten the bolts so the
ARC WASHERS (M6) (65)
press against and secure the
ROPE (51)
in position. Re-attach the
HANDLEBAR COVER (52)
with the
SCREWS (M4x15mm) (49).