LifeSpan SM-410, User Manual

15

2.

    Get access to the set-up mode of TIME/DISTANCE/CALORIES/PULSE.

        When you are in each set-up mode, for example in the time set-up mode: time value is blinking,      
        you can press "SET" button to adjust the value and press "MODE" for confirmation. The set-up of           
       DISTANCE, CALORIES & PULSE is the same as TIME.

3.

     With any signal been transmitted into the monitor, the value of TIME, DISTANCE, CALORIES start 

       to count up as Drawing C. When there is any function has been pre-set the target (TIME or  

       DISTANCE or CALORIES), the function will be counting down from the pre-set to zero while the 
       training starts.

       Once the target is achieved to zero, the monitor start to beep for 8 seconds, and the function will  
       be counting up from zero directly if the training is going. Press "MODE" button for confirmation         
       and skip to next set-up.

COMPUTER OPERATION  |

Drawing A

Drawing B

Drawing C

4.

    In SCAN mode shown as "Drawing C". RPM/ 

       SPEED/TM/DIST/CAL/PULSE will skip to  
       display in every 6 seconds. The order is as  
       follows.

5.

    You can also press "MODE" button to select  

       single function display except RPM & SPEED  
       function. The RPM & SPEED function will  
       switch display.