17
VII. EXERCISE COMPUTER
INSTRUCTION MANUAL
OVERVIEW:
MODE OR FUNCTION
ACTION
Power on
If push the button, the unit will be on and display the parameters of the last
exercise.
Select function Scan
Push the button, the unit will display 5 parameters one by one. Push the
mode key until the "SCAN" signal shows on right down side. The unit will
scan by through Time, Speed, Distance, Calories and Pulse each for 4 sec-
onds.
Odometer(If have)
Push the mode key again, the scan will stop and the "SCAN" signal will dis-
appear. If push the button until the "ODO" points to "ODO", the display shows
the Odometer on the meter. The reading of the odometer will be reset to zero
after replacing the batteries.
Time
Push the mode key until the "TMR" points to "Time" to display the exercises
time. If the bike stop moving, the unit will stop count time also.
Speed
When the "SPD" points to "SPD" to display the speed value. Unit: km/h.
Distance
When the "DIST" points to "Dist" to display the distance value. Unit: km
Calories
When the "CAL" points to "CAL" to display the calories value. Unit: K Cal.
Pulse(If have)
When the "PULSE" points to "pulse" to display the heart rate of biker in per
minute. If the sensor is contact with ear, clip the sensor to earlobe before
measuring your pulse rate. If the pulse sensor is contact with hand, place
the palms of your hands on the both of the contact pads before measuring
your pulse rate. If the pulse signal is not in put over 30 second, the unit will
return the "Time" function.
Reset
Push the mode key over 3 seconds the showing will become to zero.
Auto off
The unit will be off if the speed signal stops over 4 minutes.
The unit is an electronic that display all workout parameters on LCD display. The workout parameters
include: Odometer (If have), Time, Speed, Distance, Calories and Pulse (If have). All workout parameters
may be selected by the select key.
EXERCISE COMPUTER INSTRUCTION MANUAL |
Summary of Contents for SP-310 M2
Page 20: ...WWW LIFESPANFITNESS COM AU...
