5
4
5. Attach the Seat (11) to the Seat Post (10) with three
Seat Nuts (9) and three Seat Washers (8). Note:
The Seat Nuts and Seat Washers may be pre-
attached to the underside of the Seat.
Insert the Seat Post (10) into the Frame (1). Press
the Frame Bushing (4) into the Frame. Note: The
Frame Bushing may be pre-assembled.
Next, align one of the holes in the Seat Post (10)
with the hole in the Frame (1). Insert the Seat Pin
(31) through the Frame and the Seat Post to select
the desired seat height.
Make sure to insert the
Seat Pin through one of the holes in the Seat
Post; do not insert the Seat Pin under the Seat
Post.
Tighten the Seat Pin into the Frame.
Battery Door
Batteries
7
8
11
1
8
31
9
Console
Wire
Console
Plate
9
10
R
L
R
22
21
6
20
6. Identify the Right Pedal (22). (The Right Pedal is
marked with an ÒR.Ó) Using an adjustable wrench,
tighten the Right Pedal
clockwise
into the right arm
of the Crank (20).
Tighten the Left Pedal (21)
counterclockwise
into
the left arm on the Crank (20).
7.
Make sure that all parts are properly tightened before you use the exercise cycle.
4
4. The Console (7) requires two "AA" batteries (not
included). Alkaline batteries are recommended.
Refer to the inset drawing. Remove the battery door
from the back of the Console. Press two batteries
into the battery compartment.
Make sure that the
negative ends of the batteries (marked ÒÐÓ) are
touching the springs in the battery compartment.
Re-attach the battery door.
Next, plug the console wire into the socket on the
back of the Console (7).
Slide the Console (7) onto the console plate. Note:
The Console attaches by friction; it does not snap
into place.
5
