-
Children must not play with the appliance.
-
Cleaning and user maintenance must not be carried out by children without supervision.
STRUCTURE
1.
FRONT GUARD
2.
BLADE NUT
3.
BLADES
4.
GUARD MOUNTING NUT
5.
BACK GUARD
6.
MOTOR SHAFT
7.
MOTOR HOUSING
8.
OSCILLATION KNOB
9.
STAND
10.
SPEED SWITCH
11.
BASE
SPECIFICATIONS:
VOLTAGE
FREQUENCEY
POWER
220-240V~
50/60Hz
38W
ASSEMBLY
1.
Implant the main body to the base correctly and firmly.
2.
Loosen the guard mounting nut from the motor housing.
3.
Place the rear guard firmly onto the motor housing, then fasten it by turning the guard mounting nut
clockwise until it is tight.
4.
Push the blades along the motor shaft, then fasten them securely by turning the blade nut anti-clockwise.
5.
Hang the front guard onto the rear guard using the position fixer on the guard's rim, then join them
together with the clips provided.
6.
Secure the front guard and the rear guard with the small screw and nut.
OSCILLATION CONTROL
1.
Use the buttons on the fan body to turn the fan on or off and to change the speed: 0 - stop; 1 - low speed;
2 - medium speed; 3 - high speed.
2.
Oscillation: Push the oscillation knob to make the fan move from side to side. Pull the oscillation knob to
stop the movement.
3.
Pitch: To change the pitch angle of the fan, push the fan guard up or down to the desired angle.
CARE AND CLEANING
To take care of your fan safely, remember to follow these instructions:
•
Before cleaning the fan, always remove the plug from the mains socket and allow the fan to stop
completely.
•
Do not allow water to drip onto or enter the fan housing.
•
Always use a soft wet cloth to clean the body, and a vacuum cleaner to clean the dust from the blades.
•
Do not use any of the following agents as a cleaner: gasoline, thinners or benzene.
•
If you believe that a malfunction may have occurred, do not try to repair the fan yourself as this may
cause a fire hazard or electric shock.
