4.
Once pairing has been confirmed, make sure the propeller is free
and clear, and give the controller a small amount of throttle to spin
the propeller.
NOTE
:
The propeller should be rotating counter clockwise when facing
the front of the board. If it is not, check the phase connector plugs to
make sure the colors match.
5.
Once the propeller is confirmed to be spinning counter-clockwise,
press the power button on the hand controller to turn it off.
CAUTION: DO NOT
transport the board with the hand controller
turned on. Always turn off the hand controller in any instance when
you’re NOT riding the eFoil.
CAUTION: DO NOT
run the motor out of the water except for a brief
check to ensure it is working correctly.
6.
Finally, inspect the board compartment seals to ensure that it is free
from damage and debris. Carefully close the lid and fasten the latches.
7.
Ensure the board compartment is sealed. You should not experience
large quantities of water in the hatch compartment after a ride.
35
3.
Power on the hand controller
by pressing the power button
above the screen. The Lift logo
will appear, followed by a battery
icon, which will appear on the
hand controller’s screen. This
confirms that the hand controller
and board are properly paired.
NOTE:
If the hand controller
screen indicates “no signal,” the
board and hand controller are
disconnected. Please review the
PAIRING THE CONTROLLER
section
on p. 36.
Summary of Contents for LIFT eFOIL
