Auto Stop:
To set or to change the Auto Stop positions please refer to the inlcuded Auto Stop
instructional manual.
Control Panel:
The control panel works the same as the remote controls. Press UP to go up and DN to
go down. Press the light button to turn the canopy light on or off. Press the lock/unlock
button for 5-10 seconds to lock the control panel. Press it again for 5-10 seconds to unlock
the control panel. When the control panel is locked the lights will blink for a set amount
of time and then stop. The Bluetooth App will still work when the control panel is locked.
When plugged into power the READY light will be a solid green and the Bluetooth symbol
will blink blue. When you pair a phone through bluetooth the light will be a solid blue and
no longer flash. The STATUS light will turn solid red when any button is pushed. If the
remotes work and the control panel doesnt or vise versa, unplug the unit from power for 2
minutes. If the control panel is locked the lights will flash when you press any button.
Remote Controls:
If the remote controls stopped working but your control panel still works, simply unplug
the motor from the battery. After one-minute plug the motor back into the battery and the
remote controls should work. If they do it means the remotes were put into a safety mode
because your batteries are over charge.
Along with the two remote controls that came with
your motor you can also download the phone app and control your motor with your phone. See
the included Bluetooth instructions.
Off-Season Storage:
Do not cover your winch with a plastic bag and seal it. This will create condensation during
off season months.
Power Outage:
In case of a power outage, use the provided back up bit (inside white floatie) on the end of
the shaft with your drill. Visit our website to watch a video on how to use the back up bit.
Power Requirements:
Our DC Motors can be 12 volts or 24 volts.
If running 24 volts make sure to hook your
batteries up in a series. (See image on right)
We recommend 24 or 27 series deep cycle batteries.
Maintenance:
Our motors are self-lubricating and do not need any maintenance.
Solar Panels will evaporate water so make sure to check water
levels in the battery to prevent battery damage and possible battery explosion.
We recommend all solar panels use a charge control to prevent over charging. They can
be purchased separate.
Website:
Go to www.lifttechmarine.com for more information, troubleshooting and how to videos.
We would like to take this opportunity to say thank you. We value you as a customer.
Should you ever have an issue please give us a call at 866-319-8877 or send us an email at
customerservice@lifttechmarine.com
Summary of Contents for DC AUTO STOP GEN2
Page 1: ......
