Liftkar MTK I 6
3.1 SYSTEM OF GOING DOWNSTAIRS
(Pictures in order 1 to 6)
Moving to a safe distance from the step margin - (4-10 cm distance wheel shaft to step margin) then STOP!
Actuate the switch (arrow forward).
The crank drive system with the small support wheels moves forward and reaches over to the next step below.
As soon as LIFTKAR is lifting, the permanently braked support wheels pull the hand truck forward over the step
margin and LIFTKAR is descending under controlled balance.
IMPORTANT
Moving to 4 - 10 cm to the step margin and STOP!
1.
As soon as LIFTKAR is lifting, let it go. Do not pull back too strongly!
2.
On winding stairs: LIFTKAR has to be turned a bit on each step so that both wheels are stopped
3.
at the same distance from the step margin.
GENERAL REMARK
Always try to find the balance.
As soon as you have this under control you will see, how easy it is to work with LIFTKAR.
3.2 SYSTEM OF GOING UPSTAIRS
(Pictures of chapter
4.1
in order 6 to 1)
Pull back to the step margin of the next step above. By actuating the switch (arrow backward) the crank drive
with the support wheels is extending backward and is lifting LIFTKAR to the next step above.
Always pull back to the step margin. On winding stairs both wheels have to be pulled back to
1.
the step margin on each step. After short exercising the switch could be pressed permanently
making it possible to work permanently and quickly.
Minimum tire pressure 2.5 bar.
2.
1
2
3
4
5
6