LIFTPRO LPO0600, Installation Instructions & User Manual

2. Obstruction Force Adjustment

CAUTION: 

The obstruction force adjustment is set automatically during 

programming. Normally no adjustment is necessary.

a)

 Press and hold 

SET

 Button until “1”appears on the display, next 

press the 

UP

 Button until “2” appears on the display to enter this 

function setting then release the button.

b)

 Press the 

SET

 button again, The unit is now in force adjustment 

mode. You will see a figure “3” with a flashing dot on the display.

c)

 Press the 

UP

 button to increase the force setting or the 

DOWN

button to decrease the force setting.

The minimum force is “1” and it can be adjusted upward. The 

maximum force is “5”.

d)

 Press SET button to confirm the settings and it will return to 

standby status automatically and display “ll”.

NOTE:

 The force is set on “3” as default.

3. Travel Speed Setting

CAUTION: If you changed the speed again, it will cancel the 

previous travel limit. The speed adjustment function will be 

available only after you reset the travel limit.

a)

 Press and hold 

SET

 Button until “1”appears on the display, next 

press the 

UP

 button until “3” appears on the display to enter this 

function setting then release the button.

b)

 Press the 

SET

 button again. The unit is now in speed adjustment 

mode. You will see a letter “A” and a flashing dot on the display.

c)

 Press the 

UP & DOWN

 button to choose the speed. Figure “8” 

means the 80% of the travel speed. Figure “A” means the full speed.

d)

 Press 

SET

 button to confirm the settings and it will return to 

standby status automatically and display “ll”.

NOTE:

 The travel speed is set on full speed “A” as default. 

SET

UP

C

ODE

DOWN

SET

UP

C

ODE

DOWN

SET

UP

C

ODE

DOWN

SET

UP

C

ODE

DOWN

SET

UP

C

ODE

DOWN

SET

UP

C

ODE

DOWN

increase force

increase speed

decrease force

decrease speed

SET

UP

C

ODE

DOWN

SET

UP

C

ODE

DOWN

13