4. Automatic Closing & Time Setting
NOTE: We recommend that Safety Photo Beams are used in any
installation where the Auto Close function is enabled.
a)
Press and hold
SET
Button until “1”appears on the display, next
press the
UP
button until “4” appears on the display to enter this
function setting then release the button.
b)
Press the
SET
button again, the unit is now in automatic close
adjustment mode. You will see a figure “0” with a flashing dot on the
display.
c)
Press
UP / Down
button once to set the auto close time (0~9).
d)
Press
UP
button to increase the time, or
DOWN
button to
decrease the time.
The close time is 15second*N, N=0~9.
The maximum time is 135s. To disable Auto Close Function, set
time to zero (0).
e)
Press
SET
button to confirm the settings and it will return to
standby status automatically and display “ll”.
NOTE:
1.
The closing time is set on “0” as standard.
2.
If the Photo Cell Function is on, and the light beam is broken by
the obstruction, the auto close time will stop for a while, and then
continue the automatic close time again.
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
increase time
decrease time
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
14
