D. Photo Cell ON/OFF Setting
NOTE
:
Make sure the photo cell has been correctly connected to the
Normally Closed contacts on the accessory terminals of the operator.
Also note that the photo beam function must be disabled if NO
photo beams are fitted, otherwise the door cannot be closed,
and the LED display will show the letter “r”.
a)
Press and hold
SET
Button until “1” appears on the display, next
press the UP button until “d” appears on the display to enter this
function setting then release the button.
b)
Press the
SET
button again. The unit is now in the photo cell ON/
OFF adjustment mode. You will see a figure “0” with a flashing dot on
the display.
c)
Press
UP / Down
button once to set the photo cell ON/OFF switch.
You can choose “0” or “1”set.
Figure “0” means, the photo cell function is closed.
Figure “1” means, the photo cell function is open.
d)
Press
SET
button to confirm the set and it will be back to standby
status automatically and display “ll”.
NOTE:
The photo cell is set on “0” as default.
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
20
