10
the indicator lights up for a moment.
After the indicator goes out, turn the
key to . “Start” position
Sedimentor indicator [Diesel truck]
In normal state, once the starter is set
to “ON” position, this lamp lights
up. After the engine is started up, it
goes out.
This lamp lights up when water in
sedimentor reaches to a certain level,
while the engine is running.
注意
如果灯亮时继续操作，燃油喷射泵就有
可能被损坏。
Transmission
oil
temperature
warning light
（
Hydraulic Forklift
）
In normal state, once the starter is set
to “ON” position, this lamp lights
up. After the engine is started up, it
goes out.
During work time if the oil
temperature
exceed
the
normal
rang(60~120
。
C) the indicator light on
Caution
If the pointer enters the red range, stop
the operation instantly and slow down
engine speed to cool the coolant and wait
until the pointer goes into the green range,
and have a check then.
Engine
fault
indicator
[Electronic-controlled engine]
When the engine gets out of order,
this Indicator will be on. then it must
immediately stop, according to an
engine fault table troubleshooting.
Can be judged according to the
fault indicator lamp (flash code), Can
be based on the fault indicator (flash
code) judgment, or ECU diagnostics
port
connected
to
diagnostic
equipment,
read
the
fault
code
information stored in the ECU.
For more information, see engine
manual
Neutral position start-up indicator
[Electric-switch]
Put the steering handle in the neutral
position when truck on the temporarily
stop, the light will indicated on
The truck can be started up only in the
neutral position.
It‟s prohibited for truck in the neutral
position sliping when it‟s on the slope.
OPS indicator [Optional]
When this light is on, it means
driver leave the seats or not sitting on
the seat correctly.
Parking indicator
Parking indicator shows on means
brake is affected, Please loosen the
parking handle (hand brake handle),
