25
Caution
Reinstall the radiator cover hood and
tighten the bolt by hand.
Fix up this part by inner hexagon bolts for
truck exported to Europe. Use socket
spanner to loose before remove; reinstall and
tighten the bolt by socket spanner
Radiator cap and coolant reservoir
The reservoir is located inside the hood.
The radiator cap is located under the
cover plate at the rear of the hood.
Warning
·When the water temperature of the
engine is higher than 70 degrees
Celsius, do not open the pressure cap
of the radiator. Loosen cap slowly to
allow steam to escape. After that,
tighten cap securely. It is good practice
to use a thick waste cloth or the like
when removing the cap.
·Do not wear gloves when removing
radiator cap.
·Antifreeze is harmful to a person, if
swallowed,
seek
medical
advice
immediately. Keep antifreeze away from
children.
Fork stopper
Use it to adjust fork spacing. Pull up fork
stopper, turn 180°, adjust fork spacing
depending on the load to handle.
1
2
3
Warning
The
forks
should
be
set
symmetrically to machine centerline and
fork stoppers should always be set
The lower beams of the fork have an
opening section to load or unload forks.
DO NOT set the forks over the
opening. Check the bolt at the middle of
the fork bracket used to prevent fork load
at the opening.
Safety step and safety grip
Safety steps are provided on both sides
of the truck body. The safety grip is located
on the left and right sides of the overhead
guard.
Use both the safety step and safety
grip when mounting and dismounting the
truck.
Hydraulic fluid reservoir cap
The hydraulic fluid reservoir cap is
located on the right side of the hood. Open
the engine hood when adding oil. Fill
hydraulic fluid through this filler port and lock
the cap after filling hydraulic fluid.
Fuel reservoir cap
