41
Warning
Hot hydraulic oil and parts will cause injury.
DO NOT touch the hot hydraulic oil and
parts
①
Put one case (volume is over 20 liters)
under the transmission.
②
Remove oil plug and drain oil.
③
Clean oil plug then install.
④
Take out the dipstick. Add hydraulic oil. See
Table for the oil used in the truck
, and then
install dipstick.
⑤
Startup engine. Step the brake pedal, get
the
engine
idle
running,
place
the
transmission in forward and backward so that
the oil enters the clutch.
⑥
Place transmission in neutral, apply parking
brake.
⑦
Take out the dipstick, inspect fluid position.
If oil is not enough, add oil to keep it between
max and mix marks
。
⑧
Check the filter and oil plug for leaks.
⑨
Shut off engine, install front soleplate.
6. Air-bleeding fuel system [Diesel]
Under the following circumstances, the need
to exclude the fuel system piping air:
•
After running out of fuel and fuel has been
added to the fuel tank.
•
After fuel system maintenance such as
changing the fuel filter and draining the fuel
filter / water separator, or replacing a fuel
system component.
7. Oil-water separator draining [Diesel]
When the sedimentor indicator lamp
lights up, it means need water discharge.
Can type
：
①
Shut the engine;
②
Place a container under the fuel filter;
③
Uplift the drain valve control rod until the
liquid is completely drained and see clean
fuel;
④
Push up drain rod until the liquid is
completely drained.
Rotary type
：
①
Shut the engine
；
②
Place a container under the fuel filter
；
③
Open the drain valve. Turn the valve 3.5
rings counterclockwise, until the valve drop
25.4mm and start to drain;
④
Drain the water in the separator until see
the clean fuel.
Caution
：
Do not screw the valve too tight when
shutting the drain valve. Over tightening will
damage thread. When shutting the valve,
uplift the valve and rotate in clockwise until
screw down.
8. Exhaust gas check
Colorless
Normal: complete
combustion
Black
Abnormal: incomplete
combustion
Blue
Abnormal: oil burns
