46
6
、
Others
1. Fuse, relay
①
Please first find out the reason before
replace damaged fuse or relay.
②
Replace with regulated standard fuse
The Control box of forklifts are placed on
left side of truck frame.
2
.
Change of tires
Warning
• When using an air compressor, first
adjust the air pressure of the compressor.
Failure to do so will cause a serious
accident, since the compressor delivers
the maximum pressure.
• To ensure safety, put the tire in a
defend casing while inflating.
Front whee
①
Park forklift truck on level concrete.
②
Start engine and raise mast about 100mm
height.
③
Place chocks behind rear wheels to
prevent movement of forklift;
④
Loosen wheel nuts 1-2 turns each by
turning them counter-clockwise;
⑤
Tilt mast fully backward, and place a
wooden block under each side of outer mast;
⑥
Tilt mast forward until front wheels are
raised from surface
;
Caution
Do not loose nuts before the front wheels
leave the ground.
⑦
Support truck by putting wooden blocks
under both sides of the front truck frame. Stop
the engine.
⑧
Take out the wheel nuts and replace the
front wheel.
Caution
a. When removing tire from wheel rim, do
not remove rim set bolts and nuts before
releasing air;
b. Make sure that wooden blocks used to
support lift truck are solid, one-piece units.
c. Never get under forklift while it is
supported only by wooden blocks.
⑨
Retighten the wheel nut temporarily.
⑩
Start the engine, and take out the wooden
block.
○
11
Tilt backward the mast and lower down
the mast slowly, then take out the wooden
block under the outer mast and rear wheel.
○
12
Retighten the wheel nut with correct
torque.
○
13
Adjust tire pressure to specified value.
