USER MANUAL
–
HDN
–
EN VERSION 02.01
Liftup A/S
| Hagensvej 21 | DK-9530 Støvring | Denmark |
T:
+45 96 86 30 20 |
M:
support@liftup.dk | www.liftup.dk | CVR DK-1015 3964
15
12.
Maintenance
12.1
Cleaning
General cleaning may only be done using a well-wrung cloth. Do NOT use a high-pressure jet
or rinse the HDN lift directly using a hose.
IMPORTANT!
Do NOT use a high-pressure jet or rinse the lift directly using a
hose. Do not use aggressive cleaning agents or similar on the lift, and avoid salt or
sand coming into contact with the lift in connection with winter maintenance.
12.2
Mechanical maintenance
The mechanical maintenance of the lifting platform shall normally only be undertaken in
connection with the regular service inspection. This is to be undertaken by an authorised service
technician several times a year, depending on whether the platform is indoors or outdoors, cf.
section 15.
Should unexpected errors or jarring sounds occur, contact your dealer at once.
12.3
Remote control
A CR2032 battery is installed in the remote controls (optional equipment).
In order to ensure reliable function, swap the batteries every 2 years
DO NOT swallow coin cell batteries
Keep batteries out of reach of small children. Should a child swallow a battery,
consult a physician immediately
DO NOT put the battery in trash. When disposing, comply with local ordinances or
regulations
Swapping the battery in a handheld remote control
•
Loosen the screw (
Torx TX 6)
on the rear of the remote
control
•
Remove the back panel
•
Swap the battery
•
Refit the back panel and test