USER MANUAL
–
HDN
–
EN VERSION 02.01
Liftup A/S
| Hagensvej 21 | DK-9530 Støvring | Denmark |
T:
+45 96 86 30 20 |
M:
support@liftup.dk | www.liftup.dk | CVR DK-1015 3964
16
13.
Pairing transmitter and receiver
13.1
Remote control and receiver 2,4 GHz
The transmitter and receiver must always be paired in order to work. This is normally done at
the factory or by
an authorized* service technician. The receiver will not react to a transmitter
which is not paired with it. A receiver can be paired with up to 20 transmitters. A transmitter
can be paired with several receivers, if required.
*Has completed a Liftup product and service course.
Pairing remote control and receiver
1.
To get access to the receiver (107500), the
top must be lifted off the lift (only a service
technician can get access to this). Then
demount the lid of the receiver box by
loosening the 4 screws.
2.
Press briefly on
’Connect’ (1). When
the
control LED begins to flash slowly, the
receiver is in installation mode for 2
minutes.
3.
Press the UP (
↑
) and DOWN (
↓
) buttons
on the remote control at the same time
and hold them down for approx. 5 seconds
until the yellow control LED on the
remote control begins to flash slowly. The
remote control is now in installation mode
for 2 minutes. It must flash yellow (If the
LED flashes red, it is an 868 MHz remote
control and pairing is not possible).
Alternatively
Press
‘
Connect
’
(S4), if the remote is open.
4.
When the control LED on the remote
control stops flashing, it is paired with the
lift.
5.
Test the system, to ensure the pairing has been performed correctly; if not, repeat 1-3
above. If you need to pair several remote controls to the receiver, repeat from step 2 above.
