ual
w
Indicator Lights
The indicator lights are located on the rear of the light.
Battery Status
The Battery Status LED is located at the
bottom of the display window. The color of
the LED represents the amount of battery
power:
Green:
100% - 75%
Amber:
75% - 50%
Red:
50% - 25%
Flashing Red:
25% - 0%
When the LED plate is installed, the Battery Status LED will be lit whenever
the Mode Switch is set to Dive mode, unless the light has experienced a Low
Power Shutdown.
Charging Status
When the light is charging, the Light Output Status LEDs will blink from
left to right. The Battery Status LED will change colors from red to green to
reflect its charge status.
Flashing Red:
0% - 50%
Flashing Amber:
50 - 75%
Flashing Green:
75% - 99%
Green:
100%
Low Power Shutdown
When the battery is drained, the Battery Status LED will flash red for five
seconds, and the light will turn off entirely.
PLEASE NOTE: After a low power shutdown, the light cannot be turned back
on until charged.
Light Output Status
The Light Output Status LEDs are seven LEDs located above the Battery
Status LED. They indicate the Sola 4000’s brightness level as follows:
1 LED
s
= 500 Lumens
2 LEDs = 750 Lumens
3 LEDs = 1000 Lumens
4 LEDs = 1500 Lumens
5 LEDs = 2000 Lumens
6 LEDs = 3000 Lumens
7 LEDs = 4000 Lumens
SOS Mode
When the light is in SOS Mode, the Light Output Status LEDs will flash SOS in
time with the light, and the Battery Status LED will turn off.
Leak Detector
If the Sola 4000 detects a leak, the light will turn itself off, and the Light
Output Status LEDs will flash in a left-to-right-to-left pattern. Do not try to
charge the light if a leak is indicated.
To turn off the flashing Light Output Status LEDs, hold the On/Off switch
forward or backward for 2 seconds.
If a leak is detected, the Sola 4000 will not turn on and must be returned to
the factory for service.
http://www.uwimaging.com/support
905-0371-A
4000
Manual
Light & Motion
300 Cannery Row
Monterey, CA 93940
831-645-1525
lightandmotion.com
Tips and Tricks
• Conserve your battery by not burning your Sola 4000 at full
brightness. Your Sola 4000 has a D-ring on the bottom for attaching a
lanyard; it is recommended to tether the light to your housing in case
it comes loose.
• When using the ¾” Loc-line arms, position the light by grasping the
¾” Locline base. This minimizes any risk of accidentally popping the
light off of the arm.
Standard Warranty
Light & Motion provides a limited warranty to the original purchaser of
its products against all defects in original workmanship and material,
under normal use and service, for two years from the date of purchase
with the following exceptions:
• Batteries are warranted for 90 days • Cosmetic discoloration of
surfaces
Light & Motion will not be liable for any further loss, damages, or
expenses, including incidental or consequential damages directly or
indirectly arising from the sale or use of this product. Products not
manufactured by Light & Motion are not covered under the Light
& Motion warranty. These products are covered by the Terms and
Conditions set forth by their respective manufacturers.
Important Information:
• Always store your light fully charged • Always lock the control switch
when traveling or in storage • Never leave your equipment in the rinse
bucket. It may be damaged by other equipment • Rinse equipment in
fresh water after every dive.
