Light Bright
Pixeldot7
Please use the original packaging or specially adapted flight cases when transporting the
device.
3. Unpacking the device
Contents of the package: The headlight, a PowerCon connection cable and Omega brackets
for mounting.
Carefully open the packaging on the top side and check the headlight and accessories for
possible transport damage. Any damage should be reported immediately to the transport
company.
4. Installation
A ready-made PowerCon connection cable is supplied with the device. Please use only the
supplied cable or a cable of the same type assembled by a specialist. The connection of the
device to the power supply must also be carried out by an authorized specialist.
Connection in Germany/Europe:
Connected loads: voltage 100-240 V, frequency 50 - 60 Hz, power max. 120W, 0.9A
The electrical safety as well as the function of the device is only guaranteed if it is connected
to a properly installed protective conductor system. It is very important that this basic safety
requirement is present. In case of doubt, have the electrical installation checked by a
specialist. The manufacturer cannot be held responsible for damage caused by a missing or
interrupted protective conductor (e.g. electric shock)! Only use the device in a completely
assembled state so that no electrical components can be touched. (
danger 100-240 V
)
If you have observed the listed points, you can plug in the devices or have them connected to
the mains by a specialist.
Leiterfarbe
Function
Symbol
Brown
Phase
„L“
Blue
Neutral conductor
„N"
Yellow/green
Protective earth
„PE“
⏚
6
