LIGHT MY BRICKS TECHNIC DIY DESIGNER LIGHT KIT INSTALL ATION GUIDE
INSTALL ATION GUIDE
20
Extras
That leaves a range of miscellaneous items like Adhesive Squares,
LEGO plates, pins and cones.
We’ve included a number of Adhesive Squares in the Designer Kit for
you to use in a variety of ways. They are great for mounting small
battery packs inside of a vehicle or attaching bit lights to areas
where no studs or plates are available. Use them also to neatly
organise wiring on a more complex design that strays from the
typical automobile structure.
The variety of transparent plates included in your kit are reserved
for swapping out specific LEGO Technic tiles that will not allow a bit
light to sit under. We’ve included the most commonly used and most
practical pieces for these kinds of situations, however you aren’t
limited to these specific tiles! Should your designers intuition take
you further, you can source any kind of LEGO component you may
need from an authorised LEGO retailer.
INTRO
BE YOND THE KIT / UPGRADING
