10.)
Remove the original trans red tile and discard. We are unable
toinstall a bit light underneath this particular tile as it is at.
Take one bit light with 15cm cable and place the LED component directly
over the top of the grey stud. Ensure the LED component is facing the
correct way up and then secure it in place by connecting the trans red 1x1
plate (provided in this kit) directly over the top. Ensure the cable is facing
toward the left, as pictured below.
11.)
Reconnect this tail light section with bit light installed back to
theBeetle.
Summary of Contents for Volkswagen Beetle LED Lighting Kit
Page 15: ......
