LIGHT PROGRESS
STICK-AL [eng]
Nov-2019
Pag. 8/16
UV-STICK-AL POWER SUPPLY CABLE - DEVICE INSTRUCTIONS
The UV-STICK must be connected to the power supply line through a specific cable
supplied (cod.
In-Cable-3.0-AL
).
1) For the correct coupling, insert the connector on the cable (cod.
In-Cable-3.0-AL
) into the connector on the device,
always checking that the pins are positioned in a way that pin (1) engages perfectly in pin (2).
Be careful that an excessive effort in the coupling is indicative of an incorrect installation!
2) Turn the ring nut (3) so that the retainers (4) on the connector body fit perfectly into the openings on the ring.
3) To properly disconnect the connectors, turn the ring nut (3) and take out the connector by pulling it to the body (5).
CAUTION: Do not remove the connector by pulling the cable.
